Configure the following settings:

Name—If necessary, change the name of the device.

Probe—Verify that the suggested Probe is correct. Mitel Performance Analytics preselects the Probe that was created by the Flex Deployment Wizard. If needed, select a different Probe from the drop-down list.

Container—If necessary, change the Container where the device is located.

Description—Enter a description for the device.

In the IP Address/FQDN field, enter the address or domain name of the device.

If no Probe is used, the IP address or domain name must be reachable from Mitel Performance Analytics. If a Probe is deployed, the IP address or domain name must be reachable from the Probe.

Select the Enabled check box to enable fault and performance monitoring.

Configure the DSCP to use for ping packets. You can choose from Best Effort (0), High Priority (46), or a variety of Assured Forwarding (AF) or Class Selector (CS) settings.

Configure the following settings:

SNMP Version—SNMP v1, v2C or v3.

SNMP Port

Community String

SNMP support must be enabled for the device with the same community string as that configured in Mitel Performance Analytics.

Ensure the device is configured to:

Allow management traffic from the Probe for off-net monitoring or from the Internet for on-net monitoring.

Send SNMP traps to the Probe if you want the Event Stream panel to appear on the device dashboard.

Select the Display Event Stream check box to have the Event Stream panel display on the device dashboard. See "Event Stream Panel" for details.

To enable Interface Filtering, enter the following information:

Names

Types

See "Interface Filter Configuration" for details.

Select the Enabled check box to enable maintenance mode for the device. Enter a message to display when the device is in Maintenance Mode.