Configuring Mitel Performance Analytics for a K8s Cluster

Do the following steps:

1. From the device dashboard, select System Administration > K8s Cluster Settings.

2. Configure the following settings:

Setting	Description
General Settings	Configure the following settings: Name—If necessary, change the name of the K8s Cluster. Probe—Verify that the suggested Probe is correct. Mitel Performance Analytics preselects the Probe that was created by the Flex Deployment Wizard. If needed, select a different Probe from the drop-down list. Container—If necessary, change the Container where the device is located. Description—Enter a description for the K8sCluster.
Maintenance Mode	Select the Enabled check box to enable maintenance mode for the device. Enter a message to display when the device is in Maintenance Mode.
Device Message	Optionally specify the device message.

Setting

Description

General Settings

Configure the following settings:

Name—If necessary, change the name of the K8s Cluster.

Probe—Verify that the suggested Probe is correct. Mitel Performance Analytics preselects the Probe that was created by the Flex Deployment Wizard. If needed, select a different Probe from the drop-down list.

Container—If necessary, change the Container where the device is located.

Description—Enter a description for the K8sCluster.

Maintenance Mode

Select the Enabled check box to enable maintenance mode for the device. Enter a message to display when the device is in Maintenance Mode.

Device Message

Optionally specify the device message.

3. Click Save to save your changes.

Clicking Save automatically runs a Probe connectivity check and verifies the new configuration.